Shindaiwa TILLER/CULTIVATOR ATTACHMENT Manuel de l'opérateur télécharger pdf (Page 27)

Pr o At t A c h m e n t Se r i e S

oP e r A t o r 'S mA n u A l

Drive Shaft Upper

1. Loosen clamping knob (A).

2. Pull locator pin (B) and rotate 1/4 turn counter clockwise to lockout

position.

3. Remove attachment.

4. Remove coupler (E) from upper drive shaft assembly by loosening

clamping screw (C) and removing set screw (D).

5. Remove upper ex cable (F), wipe clean, and apply a thin coating of

1/2 oz. (15ml) of grease.

6. Install cable. Make sure that the ex cable fully engages into the

clutch square drive socket.

7. Slide coupler on upper drive shaft until fully seated, and align set

screw hole in coupling with hole in upper drive shaft.

8. Install and tighten set screw (D), and tighten clamping screw (C).

Drive Shaft (Lower)

IMPORTANT

Lower and upper drive shaft must be lubricated with high tem-

perature automotive grease every 25 hours of operation, otherwise

drive shaft assembly overheating and failure can result.

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull exible cable from the drive shaft housing, wipe clean and

re-coat with a thin coating [15 ml (1/2 oz.)] of POWER BLEND-

3. Slide the exible cable back in the drive housing. DO NOT get

dirt on the ex cable.

4. Install the gear housing and shield assembly.

IMPORTANT

Flat edge of washers (D) must be against drive shaft.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Pas de commentaire

Shindaiwa TILLER/CULTIVATOR ATTACHMENT Manuel de l'opérateur Page 27