Shindaiwa X7506720300 Manuel de l'opérateur télécharger pdf (Page 11)

11

10-Hour Maintenance

Loosen

thumbscrews

Figure 13A

(more frequently in dusty conditions)

Remove the air lter cover by loos-1.

ening the two thumbscrews. See

Figure 13A.

Remove and inspect the pre-lter. 2.

If the pre-lter is torn or otherwise

damaged, replace it with a new

one. See Figure 13B.

Clean the pre-lter with soap and 3.

water. Let dry before reinstalling.

Inspect the air lter element. If the 4.

element is damaged or distorted,

replace it with a new one.

Tap lter gently on a hard surface to 5.

dislodge debris from element or use

compressed air from the inside to

blow debris out and away from the air

lter element.

Filter

Element

Pre-lter

CAUTION!

Never operate the unit if the air lter

assembly is damaged or missing!

IMPORTANT!

Direct the air stream at the inside face

of the lter only!

Figure 13B

Install the lter element, pre-lter 6.

and cover in the reverse order of

removal.

Every 10 to 15 hours of operation:

CAUTION!

Before removing the spark plug,

clean the area around the plug to

prevent dirt and debris from getting

into the engine’s internal parts.

Clean the spark plug

and check the gap at

the electrode.

10/15-Hour Maintenance

0.6 mm

(0.024 inch)

Figure 14

NOTE:

The NGK CMR5H also meets the

requirements for electro magnetic

compliance (EMC).

Remove and clean the spark plug.

■

Adjust the spark plug electrode gap

to 0.6 mm (0.024 inch). If the spark

plug must be replaced, use only an

NGK CMR5H or equivalent resistor

type spark plug of the correct heat

range. See Figure 14.

Maintenance (continued)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire