Shindaiwa 400 Manuel de l'opérateur télécharger pdf (Page 29)

10. Simultaneous Use of Welding and Generating

The circuit breakers (3-P and 1-P) react on the AC power supply circuit only. In the

simultaneous use of welding and generating, there sometimes happens overload to the

engine. Refer to the following table and limit the AC power use.

Limitation of AC Power Supply in the simultaneous use of welding and generating (60Hz)

Welding Output AC Power Output

Welding Rod

/ Amperage

Output

Select

3-Phase 380-415V Output

(P.F. 0.8)

1-Phase

Output

φ2.0mm/60A Dual 9.0kVA 10.5kVA

φ2.6mm/120A Dual 8.5kVA 9.0kVA

φ3.2mm/140A Dual 8.0kVA 8.5kVA

φ4.0mm/170A Dual 7.5kVA 7.5kVA

φ5.0mm/240A Single 2.5kVA 5.0kVA

φ6.0mm/300A Single 2.0kVA 2.5kVA

φ8.0mm/380A Single 0kVA 0kVA

 In order to secure stable AC output, the output selector switch should be positioned

to DUAL in operation as long as possible.

 The 1-Phase output is the total of 1-Phase from the receptacle and 1-Phase from

terminals.

z The simultaneous use of Eco welding and AC power is NOT available.

z Avoid the simultaneous use in the case high quality result in welding is

required.

11. Checking and Maintenance

Danger : Electric Shock・Injuries

z Before performing any equipment check or maintenance, stop the engine, and

remove engine key. A person performing the maintenance should always keep

the key.

Caution: Fire・Burns

z Keep the equipment far away from fire.

z When checking engine, always stop the engine, and keep away from fire. Wait

until the engine cools down, before performing any checks.

z The authorized technicians should perform all checking and maintenance work,

except for the pre-startup checks.

z Request for the maintenance item with ● mark to the authorized distributor or

our engineering section.

z Always use our genuine parts of replacement.

To optimize the use of this generator/welder, we recommend the periodical equipment

checks and maintenance based on the following matrix.

Use the hour meter as a guide for the operating time.

- 28 -

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Shindaiwa 400 Manuel de l'opérateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Shindaiwa 400