Shindaiwa DH254 Manuel de l'opérateur télécharger pdf (Page 9)

Slide ignition to ON

Fast Idle

Button

Make sure the

attachment is clear

of obstructions!

...and pull recoil

starter handle

upward

Hold

the unit

rmly...

Open

After engine starts,

move choke to OPEN position

choke

Set the choke lever to the CLOSED position

Starting the Engine

IMPORTANT!

Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and “O” for OFF

or STOP.

1. Slide the ignition switch to the “ON”

position.

2. Set the throttle trigger to the “fast

idle”:

WARNING!

Never start the engine from

the operating position.

IMPORTANT!

The primer system only pushes fuel

through the carburetor. Repeatedly

pressing the primer bulb will not ood

the engine with fuel.

CAUTION!

Do not pull the recoil starter to the

end of the rope travel. Pulling the

recoil starter to the end of the rope

travel can damage the starter.

WARNING!

The attachment will operate immediately when the engine starts, and could result in possible serious injury.

Keep movable parts of the attachment away from objects that could become entangled or thrown, and surfaces that

could cause loss of control.

IMPORTANT!

If the engine fails to start after several

attempts with the choke in the closed

position, the engine may be ooded

with fuel. If ooding is suspected, refer

to the ”Starting a Flooded Engine”

section of this manual.

6. When the engine starts, slowly

move the choke lever to the “OPEN”

position. (If the engine stops after

the initial start, close the choke and

restart.)

7. Operating the throttle will automati-

cally disengage the fast idle setting.

■ After the engine starts, allow the

engine to warm up at idle 2 or 3

minutes before operating the unit.

■ Advancing the throttle makes the cut-

ting attachment move faster; releasing

the throttle permits the attachment to

stop moving. If the cutting attachment

continues to move when the engine

returns to idle, carburetor idle speed

should be adjusted. (See “Adjusting

Engine Idle”.)

When the Engine Starts...

a. Depress and hold the throttle

interlock, then squeeze the throt-

tle trigger.

b. Depress and hold the fast idle

button.

c. Release the throttle trigger and

throttle interlock, then release fast

idle button.

3. Press the primer bulb until fuel

can be seen owing in the trans-

parent return tube.

Throttle Trigger

Throttle Interlock

Primer Bulb

4. Set the choke lever to the CLOSED

position if engine is cold.

5. While holding the outer tube rmly-

with left hand. Use your other hand

to slowly pull the recoil starter han-

dle until resistance is felt, then pull

quickly to start the engine.

Press primer bulb...

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Shindaiwa DH254 Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils de jardin Shindaiwa DH254