Shindaiwa 357 Manuel de service télécharger pdf (Page 121)

Q Shindaiwa Inc. 1995 121

Model 357 Top Handle Saw Section 13

Remove the Starter Assembly (Figure 13.8)

STEP 1. Remove the four starter assembly

mounting screws, noting the orientation of

the chain brake support arm and metal

spacer.

STEP 2. Lift out the black plastic air baffle,

and expose the ignition coil and cylinder

fins.

Remove the Flywheel and Ignition

STEP 1. Insert an appropriate piston stop in

the spark plug hole, and then use a 14 mm

wrench to remove the flywheel nut in a

counter-clockwise rotation (Figure 13.9).

STEP 2. Remove the black plastic inner baffle

plate.

STEP 3. Use Shindaiwa puller p/n 22150-

96101 to remove the flywheel assembly

from the crankshaft (Figure 13.10).

STEP 4. Unplug the switch wire from the top

of the ignition coil, remove the two 4 mm x

20 mm coil mounting screws, and then

remove the coil. When removing the ignition

coil, note the use and orientation of the two

brown insulators separating the coil from

the cylinder.

IMPORTANT!

To remove the coil without removing the

powerhead, remove the spark plug boot

from the high-tension lead.

RHV-55

Teardown

(continued)

Figure 13.7 Pump Cover and Engine Mount

Oil Pump

Pump

Cover

Engine Mount

Screw

35766

Figure 13.8 Remove the Four Starter Screws

Brake

Support Arm

Spacer

Figure 13.10 Removing the Flywheel

35753

p/n 22150-96101

35752

Flywneel Nut

Inner Baffle

Plate

Figure 13.9 Removing the Flywheel Nut

Cover Screw

Spark

Coil

MODEL 357

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 137 138

Commentaires sur ces manuels

Pas de commentaire