Shindaiwa EB8520RT Manuel de l'opérateur télécharger pdf (Page 24)

Maintenance and care

Replacing fuel filter

Tools required: 200-250 mm (8-10 in.) length of wire with

one end bent into a hook, clean rag, funnel,

and an approved fuel container

Parts required: Fuel line and filter

1. Use a clean rag to remove loose dirt from around fuel cap

and empty fuel tank.

2. Use the "fuel line hook" to pull the fuel line and filter from the

tank.

3. Remove the filter from the line and install the new filter.

Carburettor adjustment

Tools required: Screwdriver, tachometer (P/N 99051130017)

Parts required:None

Before Adjustment

Check that:

Air filter is clean and properly installed.

Spark arrestor screen is free of carbon.

Blower pipes are installed.

1. Place the blower on the ground and start the engine, then al-

low it to idle 2-3 minutes until warm.

2. If a tachometer is available, the engine idle speed should be

final adjusted to 2000(±200) r/min.

1. Fuel filter

3. Fuel line hook

2. Fuel line

4. Fuel tank

DANGER

Fuel is VERY flammable. Use extreme care when mixing,

storing or handling.

NOTE

If filter is excessive dirty or no longer fits properly, replace it.

NOTE

Every unit is run at the factory and the carburettor is set in com-

pliance with Emission Regulations. This carburettor does not

have acceleration and high speed adjustment needles.

1. Idle adjustment screw

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 135 136

Pas de commentaire

Shindaiwa EB8520RT Manuel de l'opérateur Page 24