Shindaiwa 89291A Manuel de l'opérateur

SHINDAIWA GRASS TRIMMER TO BLADE CONVERSION INSTRUCTIONSWARNING!Minimize the risk of injury to yourself and others! Read the Owner's/Opera-tor&ap

10Shoulder Strap NOTE:Although a shoulder strap accessory is not required for use with a grass trimmer, a shoulder strap can increase operator comfor

11WARNING! Before working with a blade-equipped unit, always inspect and clear the area of objects that could interfere with or damage the blade.

ECHO Incorporated.400 Oakwood RoadLake Zurich, IL 60047-1564 U.S.A.Telephone: 1-877-986-7783Fax: 1-847-540-8416www.shindaiwa.com Yamabiko Corporation

2CAUTION!A statement preceded by the word “CAUTION” contains information that should be acted upon to prevent mechanical damage.IMPORTANT!A statement

3Safety and Operation Information Labels: Make sure all information labels are undamaged and readable. Immediately replace damaged or missing informat

4AssemblyRemoving the Existing Cutting Attachment Shield 1. Remove the four socket-head cap screws (A), bracket (B) and two shims (C). 2. Remove th

5Install Hanger1. Position the hanger (A) on the outer tube (B) between the handle and throttle assembly and secure the hanger with the nut (C) and b

6Barrier Bar and Hanger Assembly1. Install the barrier bar (H) with the socket-head cap screws (A) and nuts (I). Tighten the screws nger-tight ONLY a

7Install New Cutting Attachment ShieldSub-Shield. (when trimmer head is in use)1. Attach the sub-shield (G) extension to the cutting attachment shiel

826107D1CB1A1FGEB1The unit should now be completely assembled and ready for use with a blade.IMPORTANT!Units with adjustable carburetors must be readj

9Gear Case with side-mounted locking tool hole: 1. Turn the unit over so that the gearcase output shaft faces UP.2. Align the notch in trimmer head