Shindaiwa BP35 Manuel de l'opérateur télécharger pdf (Page 18)

Guard plate installation

(For nylon line operation)

 Attach the guard plate to the shield.

Nylon line head installation

(Use with guard plate)

1. Blade retainer. 2. Locking tool (4 mm hexagonal wrench). 3. Socket wrench.

4. Loosing direction. 5. Bolt. 6. Bolt guard.

 Align locking hole in blade retainer with notch at the edge of angle transmission and insert

locking tool.

 The bolt has a left hand thread and can be removed by turning clockwise.

 Remove the bolt guard.

7. Nylon line head

 Mount line head to output shaft by turning it anticlockwise until head is tight against blade

retainer.

 Remove locking tool.

WARNING

The cut off knife on the debris shield has sharp edges.

Avoid contact when installing or removing the line head.

NOTE

Make sure the guard plate is completely hooked at the hook receiver.

CAUTION

Fasten output shaft using locking tool securely in order to avoid the possibility of

output shaft rotating when mounting nylon line head.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 91 92

Pas de commentaire

Shindaiwa BP35 Manuel de l'opérateur Page 18