Shindaiwa 326T Manuel de l'opérateur télécharger pdf (Page 24)

English

For setting saw chains, round le (4 mm ø: 5/32”) and at le are used.

To keep correct position and correct angle, use the le holder. ■

Round le and at le are available from your Shindaiwa Dealer. -

File cutters as below. ■

Type : 91VG

HOLD FILE HOLDER LEVEL

Depth gauge

ONE FIFTH OF FILE DIAMETER REMAINS

ABOVE CUTTER EDGE

To sharpen other type chain, follow chain manufacturer’s instructions

30°

PUSH FILE AS SHOWN

Keep this angle

1/5

90°

SETTING THE SAW CHAIN

The following combinations may be used on 326T.

Ch a i n a n D gu i D e ba R Co m b i n a t i o n s

IMPORTANT

Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.

IMPORTANT

If your kick guard is damaged or lost, contact your Shindaiwa dealer for a replacement.

WARNING DANGER

Use of replacement saw chain and/or guide bar other than that specied, or operation without the “tip guard” in place,

may cause severe kickback resulting in serious injury.

Only use saw chain designated as “LOW-KICKBACK” that meets the ANSI B175.1-2000 Standard and the guide bar

specied.

*Reduced nose radius symmetrical bars (OREGON name — Double Guard)

Model Bar Length Low Kickback

Guard Bar

Low Kickback Saw Chain

Bar P/N Chain P/N Links Type Pitch Gauge

326T

12” 120GPEA041 91VG-45 45

91VG 3/8” .05014” 140GPEA041 91VG-52 52

16” 160GPEA041 91VG-57 57

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 89 90

Pas de commentaire

Shindaiwa 326T Manuel de l'opérateur Page 24