Shindaiwa M230 EMC Manuel de l'opérateur télécharger pdf (Page 14)

14

23042

Hold the grass trimmer so the trimmer

head is angled slightly into the area to be

cut. To ensure maximum trimmer-line ser-

vice life, cut only

with the tip of the

trimmer line. Cut

grass by swinging

the unit's trimmer

head from left to

right. Keep the

trimmer head

horizontal.

Edging

Tilt the handle about 100°

to the left (from horizon-

tal) and move forward,

holding the trimmer verti-

cally as shown.

Your Shindaiwa T230 Grass Trimmer may

be equipped with one of several Shindaiwa

trimmer head models, each with features

for speciﬁc applications and/or operational

requirements.

NOTE:

A grass trimmer head can also be ﬁtted to the

Shindaiwa C230 Brushcutter.

For proper operation, always refer to the

instructions accompanying the trimmer

head being used. Available trimmer head

styles include:

 Semi-automatic. Trimmer line is

indexed when the operator taps the

trimmer head on the ground during

operation.

 Manual. The operator indexes line

manually with the grass trimmer

stopped.

CAUTION!

Do not push the rotating line into trees,

wire fences or any material that could

tangle or break line ends.

Using a Grass Trimmer T230

CAUTION!

Operation at low RPM can lead to pre-

mature clutch failure.

Trimming and Mowing Grass

Figure 31

Engine Operating Speeds

Operate at full throttle while cutting grass.

Figure 32

23041

 Fixed. The operator must stop the unit

and add new lengths of trimmer line

manually.

 Flail. This device, designed for clearing

weeds and light brush, features three

nylon blades attached to the head by

pivots.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire