Shindaiwa BCK-11 Manuel de l'opérateur télécharger pdf (Page 6)

Install Handlebar Mounting Bracket and Handlebar

Assembly

1. Remove 2 lower cap screws (A), and remove lower cap (B).

2. Place the handlebar mounting bracket (C) and 2 spacers (D) on the outer

tube, and secure with lower cap and 2 screws.

3. Remove 4 upper cap screws (E) and remove upper cap (F).

4. Remove handlebar clamp (G) from mounting bracket, and unscrew 4

screws to separate clamp.

5. Install handlebar clamp (G) on handlebar (H), and secure with 4 clamp

screws.

IMPORTANT!

Screw heads must face down to permit handlebar adjustments after upper

cap (F) is installed on handlebar mounting bracket (C).

6. Place handlebar clamp into mounting bracket, and seat clamp in rubber

anti-vibration cushion.

7. Place upper cap (F) on handlebar mounting bracket. Make sure anti-vibra-

tion cushions in upper cap t properly on top of handlebar clamp. Secure

with 4 screws (E).

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Shindaiwa BCK-11 Manuel de l'opérateur Page 6