Shindaiwa BCK-11 Manuel de l'opérateur télécharger pdf (Page 8)

Install New Cutting Attachment Shield

Assemble the Cutting Attachment Shield to the Outer Tube.

1. Insert the cutting attachment shield

(A) between the outer tube and the

cutting attachment mounting plate (B).

2. Fit the two shims (C) and the upper

clamp (D) over the outer tube and in-

stall the four socket-head cap screws

(E) nger tight.

CAUTION!

Make sure the clamp screw and re-

taining nut (F) are securely tightened

before tightening the four socket head

screws.

3. Tighten the four socket-head cap

screws to secure the cutting attach-

ment shield.

Sub-Shield.

(when trimmer head is in use)

1. Attach the sub-shield (G) extension to the cutting attach-

ment shield (A).

WARNING!

NEVER use this machine without sub-shield when us-

ing a trimmer head.

CAUTION!

Make sure the sub-shield is completely hooked at the

hook receiver.

WARNING!

NEVER operate the unit without the cutting attachment

shield installed and tightly secured!

WARNING!

A cutting attachment shield or other protective device is

no guarantee of protection against ricochet. YOU MUST

ALWAYS GUARD AGAINST FLYING DEBRIS!

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Shindaiwa BCK-11 Manuel de l'opérateur Page 8